On Januwe adopted, via Safety and Enforcement Division’s (SED) disposition of a Tier 1 Advice Letter, the final CPUC Fire-Threat Map. On December 21, 2017, we completed the second track of R.15-05-006 by issuing Decision (D.) 17-12-024 which adopted regulations to enhance fire-safety in the HFTD. The second track focused on the identification, evaluation, and adoption of fire-safety regulations in the HFTD. One track focused on the development and adoption of a statewide fire-threat map. The scope and schedule for R.15-05-006 was divided into two parallel tracks. Revise GO 95 to include a definition and maps of the HFTD, as well as any new fire-safety regulations.Figure out the need for more fire-safety regulations in the HFTD, and.Create and adopt a statewide fire-threat map that outlines the boundaries of a new High Fire-Threat District (HFTD) where the previously adopted regulations will apply,.The general scope of R.15-05-006 was to complete these unfinished tasks: To solve these issues, we started to create a single statewide fire-threat map to select areas with a higher risk for destructive power line fires and where stricter fire-safety regulations should apply. Each of the interim maps covers a different part of the State and uses its own method for showing high fire-threat areas, showing consistency and potential enforcement issues. These high fire-threat areas are chosen by several maps that were approved on an interim basis. Several adopted fire-safety regulations apply only to areas, referred to as “high fire-threat areas,” where there is a higher risk for power line fires igniting and spreading rapidly. Most of the adopted fire-safety regulations consisted of new or revised rules in General Order (GO) 95. In 2009, we issued several decisions in R.08-11-005 that together adopted dozens of new fire-safety regulations. In response to these wildfires, we created Rulemaking (R.) 08-11-005 to consider and adopt regulations to protect the public from potential fire hazards associated with overhead powerline facilities and nearby aerial communication facilities. Several of the worst wildfires were reportedly ignited by overhead utility power lines and aerial communication facilities near power lines. However, users are encouraged to refer others to the Department of Forestry and Fire Protection to acquire the maps, in case updated maps become available.ĭue to the nature of this content, some users who require Assistive Technology may experience accessibility issues.In October 2007, devastating wildfires driven by strong Santa Ana winds burned hundreds of square miles in Southern California. There are no restrictions on distribution of the maps by users. The user will cite the Department of Forestry and Fire Protection as the original source of the maps, but will clearly denote cases where the original maps have been updated, modified, or in any way altered from the original condition. The user will not seek to hold the State or the Department liable under any circumstances for any damages with respect to any claim by the user or any third party on account of or arising from the use of data or maps. The State of California and the Department of Forestry and Fire Protection make no representations or warranties regarding the accuracy of data or maps. By downloading from this page, the user agrees to the following terms and conditions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |